General 90-200 M1, Руководство по установке и эксплуатации, Страница: 12 / 40

3. Slip the slide bracket on the rail. 4. To attach the fence to the slide bracket, slide the t-track
onto the hex head bolts as shown and then tighten the
lock knobs
to secure the fence on the bracket.
5. Lock the rip fence against the left side of the blade
and check that the pointer
is aligned with the zero
on the left part of the tape .
6. If the pointer does not align with the zero, loosen the
two bolts on the left part of the rail and slide the rail
slightly left or right. With the pointer aligned with the
zero
, tighten the two bolts so that the rail is secu-
rely fastened.
Note: When tightening the two bolts, take care in doing so not to mis-
align the pointer with the zero. Once the bolts are tightened, recheck
for pointer alignment and readjust if needed.
You will now be able to accurately read measurements from the blade to the inside face of the rip fence, with the
fence positionned to the left of the blade.
Multi-position fence:
The fence can be installed in the standard position (as
shown above) for cutting shorter stock or repositionned
on the slide bracket in the vertical position for resawing
taller stock
.
CLOSE UP
1. Position the four hex bolts with flat washers through
the holes in the rail. 2. Align the bolts in the rail to the threaded holes in the
front edge of the table and tighten the bolts to secure
the rail to the table, using the supplied 10 mm wrench.
CLOSE UP
12