General International 90-120, Руководство по установке и эксплуатации

Страница: 22 / 30

22
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
1. Insert the miter gauge into the “T” slot in the table as
shown.
2.
Position the miter gauge on the table.
USING THE MITER GAUGE
MOTOR
LUBRICATION
Frequently blow or vacuum out any sawdust from the motor. Follow lubrication instruction on the motor label.
All of the bearings are sealed and permanently lubricated. They require no further lubrication.
WHEEL TIRES
Pitch and sawdust that build up on the tires should be removed with a stiff brush or scraped off with a piece of
wood.
Note: To avoid damaging the tires do not use a sharp knife or any kind of solvent. When the tires become worn they should
be replaced. When replacing the tires, stretch them around the wheels but do not glue then on.
MAINTENANCE
CLEANING
Keep your band saw clean. Sawdust will accumulate under the table, base and in the wheel housings. This could
cause difficulty tilting the table. Frequently blow out or vacuum up the sawdust. Do not allow dirt, pitch or gum to
build up on the table, the guard, or blade guides. Clean as needed with gum and pitch remover.
Note: Do not immerse the bearings in the gum and pitch remover. Put a thin coat of paste wax on the table so that the
wood slides easily while cutting.
3.
Loosen the miter gauge lock knob.
4.
Adjust the angle as per the angle indicator scale,
and then retighten the lock knob.
Note: Use the mounting holes A to add an auxiliary fence
if needed.
A