General International 90-120, Руководство по установке и эксплуатации

Страница: 13 / 30

BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING THE RIP FENCE
INSTALLATING THE PUSH STICK HOLDER
1.
Thread the push stick holder in the mounting hole
on the left side of the machine, and tighten the jam
nut with a 10 mm wrench to secure it in place.
2. Hang the push stick to keep it handy.
3. Secure the rail in place by tightening the lock knobs. 4. Push down on the handle and place the fence on
the rail.
1.
Slide a washer onto each lock knob and loosely
screw the four lock knobs in the mounting holes in
the underside of the table.
2.
Fit the rail onto the lock knobs as shown.
13