General International 90-120, Руководство по установке и эксплуатации

Страница: 10 / 30

10
ASSEMBLY INSTRUCTIONS
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
ASSEMBLING THE CABINET
7. Attach the shelf using 4 bolts with washers D and a
10 mm wrench.
8.
Install the lower and upper cross braces
E
to the
panels as shown and secure using cap screws with
washers F and a 5 Allen key.
5. Secure the rear panel in place using 4 bolts with
washers C and a 10 mm wrench.
6. Position the shelf as shown and align its mounting
holes with the corresponding holes in the side panels.
1.
Set the right panel on the base.
2. Align the holes in the panel with their corresponding
holes in the base and insert a bolt with a flat washer
A
.
3. Attach the panel to the base using a nut and washer
on each bolt B under the base with a 10 mm wrench.
Repeat with the left panel.
4.
Slide the rear panel in place as shown.
A
B
C
D
F
E