General International 15-650 M1, Руководство по установке и эксплуатации, Страница: 11 / 32

English
11
CONNECT TO POWER SOURCE
Consult a qualified electrician for proper installation of receptacle at the
source of power. This tool must be grounded while in use to protect the
operator from electrical shock. If you are not sure if your outlet is properly
grounded, have it checked by a qualified electrician. Make sure the tool is
turned OFF when connecting the power cord to a properly grounded 120
Volts, 60 Hz, single phase, 15 amp power source.
wARNING!
Risk of injury due to accidental starting. Do not use in an
area where children may be present.
wARNING!
Prior to using the grinder, check that the eye shields, spark
deflectors, and tool rests are fitted and correctly adjusted and that you
are wearing safety gear including eye, hearing and breathing protection.
1. Hand turn the wheels to ensure they do not touch the guards, eye
shields, spark deflectors or tool rests and run freely.
2. To start grinder: push the right hand side of the switch. To turn the
grinder off, push the left hand side of the switch. The “ON” and “OFF”
positions are stamped on the switch plate.
3. If the grinder fails to start right away, switch it OFF, disconnect the power
cord and check voltage at power source.
4. Stand to one side, turn the switch on and allow the motor to reach full
speed.
wARNING!
To reduce the risk of injury, no adjustments to tool rests,
spark shields or other components should be made while the grinder
wheels are turning.
5. Support the workpiece on the tool rest as close as possible to the wheel
face and gradually feed the workpiece onto the wheel. Use vise girip
pliers to hold small workpieces.
NOTE:
Traverse the workpiece across the full width of the wheel to
prolong its flat surface.
6. If, during the grinding operation the motor speed noticeably decreases,
pull back the workpiece, allowing the motor to regain full speed. Restart
the grinding operation using less force.
7. Note that the workpiece can get very warm. It may be necessary to
cool a workpiece by dipping it in a coolant or in water, but do not apply
coolant or water directly to the grinding wheel.
wARNING!
Never grind on the side surfaces of the wheel. Grind on the
outer edge, the face (fig 3) of the wheel only.
!
!
!