General International 15-650 M1, Руководство по установке и эксплуатации, Страница: 10 / 32

English
10
ATTACHING TOOL RESTS
Tool rests are required for each high speed grinding wheel to assist in the
grinding operation.
wARNING!
To reduce the risk of injury, never use a bench grinder on
which the tool rest has not been fitted or where the tool rest has not been
correctly adjusted.
NOTE:
The tool rests are right and left handed. Follow the diagrams to
ensure the correct tool rest is fitted to the correct side.
wARNING!
To reduce the risk of injury, never connect plug to power
source outlet until all assembly steps are complete and until you have
read and understood the entire owner’s manual.
1. Hold the tool rest in the correct position against the tool rest bracket on
the wheel guard.
2. Insert a short bolt through the tool rest bracket and then the tool rest,
followed by a washer, lock washer, and locking knob.
3. Tighten the locking knob sufficiently to support the tool rest but still
allowing the tool rest to slide inwards and outwards.
4. Slide the tool rest to within a maximum of 1/16” (1.5 mm) from the
surface of the wheel.
5. Rotate the wheel one full revolution by hand to ensure the wheel does
not contact the tool rest.
6. Tighten the locking knob firmly to retain the tool rest position and angle.
7. Repeat the assembly operation for the second tool rest.
MOUNTING ThE GRINDER
We recommend you mount the grinder on a stable bench.
wARNING!
To reduce the risk of injury, never connect plug to power
source outlet until all assembly steps are complete and until you have
read and understood the entire owner’s manual.
1. Before operating the bench grinder, it should be firmly mounted to a
workbench or another rigid framework.
2. Use the holes in the base of the bench grinder (L, fig 1) to mark and pre-
drill the mounting holes. If it is to be used in one location, permanently
secure it to the work surface. Use bolts, washers, lockwashers and
nuts, keeping in mind the inherent vibration a bench grinder in operation
produces.
3. Alternatively, the bench grinder could be mounted to a piece of 3/4” (19
mm) thick plywood at least 12” x 18” (30 x 46 cm) to prevent tipping.
This could then be attached to any convenient stable support with
C-clamps when and where needed.
OPERATION
POwER SOURCE CONNECTION
POWER REQUIREMENTS
This tool is designed to operate on a properly grounded 120 volt, 60 Hz,
single phase alternating current (AC) power source fused with a 15 amp
time delayed circuit breaker. It is recommended that a qualified electrician
verify the ACTUAL VOLTAGE at the receptacle into which the tool will be
plugged and confirm that the receptacle is properly grounded. The use of
the proper circuit size can eliminate nuisance circuit breaker tripping when
using your tool.
CAUTION:
DO NOT OPERATE THIS TOOL if the ACTUAL power
source voltage is less than 105 volts AC or greater than 132 volts
AC. Contact a qualified technician if this problem exists. Improper
performance, and/or, damage to the tool will result if operated on
inadequate, or excessive power.
!
!
!
!