Table of Contents
R-panel Technical Manual
1
Table of Contents
Safety Rules ........................................ Inside Front Cover
General Information ......................................................... 2
Introduction ........................................................... 2
Control Board Dip Switch Settings ........................ 2
Generator Operation .............................................. 5
Engine Timing ........................................................ 5
Utility Failure ......................................................... 5
Manual
Mode
...................................................... 5
Auto
Mode
........................................................... 5
Exercise
Mode
..................................................... 5
Utility Restored ...................................................... 5
Initial Cranking ...................................................... 5
Active Alarm ........................................................... 6
Re-crank ................................................................ 6
Normal Exercise Mode ........................................... 6
Low Speed Exercise ............................................... 6
Auto Start .............................................................. 6
Manual Start .......................................................... 7
System Ready (Green LED Indicator) .................... 7
Low Fuel Pressure (Yellow LED Indicator) ............. 7
Low Battery (Red LED Indicator) ........................... 7
Low Oil Pressure (Red LED Indicator) ................... 7
High Coolant Temp (Red LED Indicator) ................ 7
Low Coolant Level (Flashing Red
High Coolant Temp LED Indicator) ..................... 7
Overspeed (Red LED Indicator) ............................. 7
RPM Signal Failure
(Flashing Red Overspeed Indicator) .................... 8
RPM Signal Failure During Cranking .................. 8
RPM Signal Failure During Running .................... 8
Overcrank (Red LED Indicator) ............................. 8
Invalid Cylinder Dip Switch Setting
(All Red LED's On) .............................................. 8
Alarm Cancel ......................................................... 8
Automatic Transfer Switch (ATS Mode) ................. 8
Engineered Transfer Switch
(2-wire Start GTS Mode) ..................................... 9
Voltage Regulator Adjustment .............................. 10
R-200 J1 Connector (23 Pin,
Gray=1800 rpm, White=3600 rpm) .............. 11
R-200 J2 Connector (14 Pin White) .................. 11
2A and 10A Battery Chargers ............................... 11
2A, 12VDC Battery Charger .............................. 12
10A, 12VDC Battery Charger ............................ 13
AUTHORIZED SERVICE
DEALER LOCATION
To locate the nearest AUTHORIZED
SERVICE DEALER, please call this number:
1-800-333-1322
DEALER LOCATION INFORMATION
CAN BE OBTAINED AT THIS NUMBER,
or visit the website at www.generac.com.
