Generac Power Systems MAGNUM MLT4060MVD, Руководство пользователя

Страница: 44 / 72

Maintenance
40 Owner’s Manual for MLT4060MVD Light Tower
•
Check the oil level daily. Refer to the engine
operator’s manual for the appropriate oil
specification. Make sure that the oil is correct for
special operating conditions such as a change in
season or climate.
•
DO NOT start the unit if the engine oil level is
below the add mark on the dipstick.
• Normal operating level is in the cross-hatch
pattern between the full and add markings on
the dipstick.
• Add oil only if the oil level is below the add mark
on the bottom of the cross-hatch pattern on the
dipstick.
DO NOT OVERFILL the crankcase.
•
Check the fuel level.
•
If the unit is connected to a remote start or
transfer switch, make sure the remote switch is
also off and tagged.
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to bleed the fuel lines.
Refer to the engine operator’s manual supplied with the
unit.
* Perform after the initial 50 hours of operation ONLY, then on the regularly scheduled interval as indicated in the table above.
† Generac Mobile Products recommends that oil change intervals on the ECOSpeed engine be extended to 750 hours after initial break-
in. The engine comes from the factory with a larger sump that holds 5.5 quarts (5.2 L) of engine oil. After the initial 50 hour break-in and
oil change, the sump, coupled with the larger oil filter (P/N 10000014392), allows the engine to operate up to 750 hours between
routine oil changes.
Hot, humid or dusty conditions can shorten engine oil service life, regardless of suggested oil change intervals. In extreme conditions,
determine oil life and change intervals through regular oil sampling and analysis.
Always follow the recommendations of the OEM engine manual that was shipped with the unit for specific operating instructions. If further technical
assistance is required, contact Generac Mobile Products Technical Service at 1-800-926-9768.
Table 4-1. Basic Maintenance Schedule
Item Daily
750
Hours
As
Required
Perform a daily walk-around inspection; see Inspecting the Unit 
Check Oil Level 
Check Coolant Level 
Check Fuel Level 
Check Tire Pressure 
Check All Electrical Connections 
Inspect Radiator Fins For Debris, Clean As Required 
Inspect Light Tower Winch For Proper Operation 
Replace Engine Oil and Oil Filter  *†
Belt And Belt Tension— Inspect, Adjust, and Replace if Necessary  *
Replace Fuel Filter 
Check Battery Condition 
Replace Air Cleaner Element 
Lubricate Leveling Jacks 
Fuel System— Bleed Air 
Drain Residual Water From Fuel Filter 