Generac Power Systems MAGNUM MLT4060MVD, Руководство пользователя

Страница: 33 / 72

Operation
Owner’s Manual for MLT4060MVD Light Tower 29
Preparing for Start-Up
NOTE: If the engine was run out of fuel or the fuel tank was
drained, it may be necessary to bleed the fuel lines before
starting. Refer to the engine manual supplied with the unit.
NOTE: On initial start-up, or if the engine was run out of
fuel, it may be necessary to cycle the diesel fired block
heater for a few minutes. before starting. See
Diesel Fired
Block Heater in Section 2.
Select AUTO Mode or MANUAL Mode
See Figure 3-5 . Use the select button to navigate
between AUTO and MANUAL mode on the Home
screen.
•
AUTO mode is required for programming
automatic start and stop times (see
Scheduler
Screen ), or enabling the “Night Watchman” sensor
(see Dusk to Dawn Screen .)
•
MANUAL mode is used for on-demand control of
the lights and convenience outlets.
Figure 3-5. Selecting MANUAL or AUTO Mode
LED Lights Only
Turn the 240V outlet breaker OFF. The engine will run at
low speed while operating, greatly reducing sound
emissions and fuel consumption.
LED Lights and Export Power
Turn the 240V outlet breaker ON and Load Sense OFF.
The engine will run at high speed for powering high
amperage equipment.
LED Lights and Export Power with Load Sense
Turn the 240V outlet breaker ON and Load Sense ON.
The engine will run at high speed when detecting applied
load(s) such as hand tools and low amperage equipment.
Table 3-1 illustrates the four possible combinations of
240V outlet breaker and Load Sense switch positions.
Table 3-1.
Engine Speed
Selection
Load Sense Switch
ON (I) OFF (O)
240VAC
Outlet
Breaker
ON (i)
Load
dependent—
variable speed*
High speed
1800 rpm
OFF (O) Low speed
Low speed
1350 rpm
*Engine will speed up automatically when more
power is drawn from receptacles.