Generac Power Systems GEN27WN, Руководство оператора

Страница: 22 / 26

22
Problem Cause Correction
Engine is running, but no AC
output is available.
1. Circuit breaker open or defective.
2. Fault in generator control panel.
3. Poor wiring connections or
defective transfer switch.
1. Reset or replace circuit breaker.
2. Contact local service facility.
3. Check and repair.
Engine runs good at no-load but
“bogs down” when loads are
connected.
1. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
4. Fuel pressure or mixture is
incorrect.
5. Kinked fuel line.
1. Disconnect shorted electrical load.
2. See
Essential Circuits
.
3. Contact local service facility.
4. See
Gaseous Fuel System
in the
Installation Manual.
5. Remove kink. Replace if necessary.
Engine will not start; or starts
and runs rough.
1. 15 Amp fuse missing or blown.
2. Fuel supply turned off or depleted.
3. Failed battery.
4. Fuel pressure is incorrect
1. Install (new) 15 Amp fuse. See
System Control Panel
.
2. Open fuel valve(s); check propane
tank.
3. Replace battery.
4. See
Gaseous Fuel System
in the
Installation Manual.
Engine shuts down during
operation.
1. Fuel supply turned off or depleted.
2. Fault indicator blinking.
1. Check fuel valves, fill propane tank.
2. Count blinks and refer to
Fault
Detection System
.
Loss of power on essential
circuits.
1. Generator circuit breaker is open.
2. Transfer switch problems.
1. Reset circuit breaker.
2. See the transfer switch manual.
Troubleshooting