Generac Power Systems G22, Руководство оператора

Страница: 16 / 32

16
GENERAC
®
G22 KINETIC LOG SPLITTER
6. Remove the four short Flange Bolts and Locknuts that secure the right side
Guard to the Frame using a 9/16" Socket and Ratchet to remove the right
side Guard from the Splitter (
Figure 22
).
7. Grease the Engagement Lever Grease Fittings from the front of the machine
with a few pumps of All Purpose Grease (
Figure 23
).
8. Grease the Yoke Grease Fittings from the rear of the machine with a few
pumps of All Purpose Grease (
Figure 24
).
9. Reinstall the Guards in the reverse order that they were removed.
Changing Engine Oil (Gas Engine Model)
One of the easiest methods to remove oil from this Engine is to use a siphon
style Oil Extractor. If you do not have one you can purchase it from us at 1-888-
545-6576.
Tools and Supplies needed:

Clean Approved Container for used Oil

10mm Wrench
1. Place an approved Container under the Oil Plug.
2. Remove the Oil Drain Plug with a 10mm Wrench to drain the Oil into the
Container (
Figure 25 ).
3. Reinstall the Oil Drain Plug.
4. Add oil as described in “Adding Oil and Gasoline” in Chapter 2.
Rail Maintenance
Between each use of the LOG SPLITTER, we recommend applying a rust
preventative (Fluid Film or equivalent) to any bare metal areas on the top of the
rail (
Figure 26 ). This will assure the smoothest return action of the ram.
Figure 26
Top of Rail
Right Side Guard
Short Flange Bolts
Figure 22
Short Flange Bolts
Drain Plug
Oil Dipstick
Figure 25
Grease
Fitting
Figure 24
Handle
Yoke
Grease
Fitting
Figure 23
Engagement
Lever