Generac Power Systems G22, Руководство оператора

Страница: 11 / 32

CONTACT US AT
1-888-545-6576
11
Adding Oil and Gasoline (gas engine model)
Engine Oil See Engine Manual for specific Engine capacities and
specifications
Fuel Unleaded gasoline with no more than 10% Ethanol
NOTE: Use only the recommended high detergent engine oil. Other types of oil
could cause problems operating your machine. Please refer to your Engine
Owner’s Manual for detailed oil information.
Supplies Needed:

Clean Rag

Engine Oil
1. Position the machine so the Engine is level. Remove the Oil Fill/Dipstick
(
Figure 10 ) and clean the end of it with a rag.
2. Machines are shipped with no oil . Initially add approx, 8 oz. of the oil
recommended by the Engine Manufacturer. Wait one minute for the oil to
settle.
3. Replace the Dipstick, but DO NOT screw it in to ensure an accurate reading
and then remove it to check the oil level (clean the Dipstick with the clean rag
after checking).
4. Continue adding a few ounces of oil at a time, rechecking the Dipstick until
the oil reaches the fill mark. Be careful not to overfill.
5. Replace the Dipstick and screw all the way down when full.
6. Remove the Gas Fill Cap and fill the Gas Tank with fresh, unleaded gas (with
a minimum of 85 Octane and no more than 10% Ethanol) to approximately
1" to 1-1/2" below the top of the fill neck to allow for fuel expansion (
Figure
11 ). Be careful not to overfill. Install the Gas Fill Cap before starting the
engine. See your Engine Owner’s Manual for more detailed information.
NOTE: To refill the gas tank, turn the engine OFF and let the engine cool at least
five minutes before removing the gas fill cap.
Check the Tire Pressure
Tools Needed:

Tire Pressure Gauge

Air Compressor
1. Remove the Valve Stem Protective Cap ( Figure 12 ) and check the tire
pressure with a Tire Pressure Gauge.
2. Check what the manufacturers recommended pressure is that is stamped on the side of the Tire.
3. If the pressure is too low, add air through the Valve Stem with an air hose. Do not over inflate the Tires
4. Replace the Valve Stem Protective Cap when finished.
Gas Cap
Figure 11
Oil Dipstick
Figure 10
The Engine must be level to get an accurate reading when adjusting the
amount of oil. If the machine is not level, the oil level reading will not be
accurate and may cause engine damage.
Valve
Stem
Protective
Cap
Figure 12