Generac Power Systems G22, Руководство оператора

Страница: 13 / 32

CONTACT US AT
1-888-545-6576
13
Electric Motor Model
Refer to the “Safety with Electric - Powered Machines” section in Chapter 1
before using the Electric Motor for safety warnings and specific power and
connection requirements.
Starting the Motor
1. Position your Log Splitter on flat, dry ground and chock the Wheels to
prevent the Splitter from moving during use.
2. Plug the Log Splitter Cord into a properly grounded 15 Amp, GFCI protected
outlet.
3. Pull the On/Off Switch up to start the Motor ( Figure 15 ).
Stopping the Motor
1. Push the On/Off Switch down to stop the Motor ( Figure 15 ).
2. When not using the Splitter unplug the Cord.
Resetting the Circuit Breaker
If the Motor will not run when the On/Off Switch is turned on and power is
connected to the machine, the Circuit Breaker Switch may need resetting. Read
all instructions in the “Safety with Electric - Powered Machines” section in
Chapter 1 to eliminate the typical causes for Circuit Breaker activation.
1. Push the Circuit Breaker Switch in to reset ( Figure 15 ).
Splitting Logs
Note: All logs should be no longer than 18". Refer to the following photos for the
correct and incorrect methods of splitting logs. Never split a log using an
incorrect or unsafe method.
Figure 18
Figure 17
Figure 16
On/Off
Switch
Figure 15
Circuit
Breaker
Switch

Do not place your hands on the ends of the log when loading the Log
Splitter. This is a very UNSAFE method and could result in injury to your
hands (
Figure 16 ).

Do not reach or step across the beam while the Log Splitter is running.
This is a very UNSAFE method which could cause personal injury or even
death.

Never attempt to split wood across the grain. The Log Splitter was not
designed for cross-grain splitting. Doing so could damage the Log
Splitter and may cause personal injury (
Figure 17 ).

Make sure both ends of the log you are splitting are cut as square as
possible. This will prevent the log from sliding out of position while under
pressure (
Figure 18 ).
Make sure the On/Off Switch is in the OFF (out) position before plugging the
cord into the outlet.