Generac Power Systems 6.75, Руководство оператора

Страница: 12 / 40

12
GENERAC
®
TRIMMER/MOWER
Electric Starting
Note: Use the following steps with Electric-Starting models only.
1. Push the Throttle Control Lever all the way forward to the Run position
( Figure 12 ).
Note: The 8.75 models do not have a Choke or Primer Bulb. Step 2 can be ignored.
2. For 6.75 Electric Start models only, push the Primer Bulb in and completely
release it, lifting your finger and letting it pop back to its original position.
Repeat three to four times. For 7.25 Electric Start models only, move the
Choke Lever left to the CHOKE position (
Figure 11 on previous page ).
Note: “Priming” or “Choking” the Engine is usually not necessary when restarting a
warm Engine. In cool weather, you may need to repeat the priming operation.
3. Turn the Key to the START position until the Engine starts, then release. The
Key will snap back to the RUN position and the Engine will continue to run.
Note: Do not engage the Trimmer Head Engage Bar until after the Engine has
started.
4. For 7.25 Electric Start models only, once the engine has started, move the
Choke Lever right to the RUN position.
Stopping the Engine
Note: If you have an Electric-Starting model, please note that the Key does not stop
the Engine. You must follow these instructions to stop the Engine for both Electric
and Manual-Starting models.
1. Move the Throttle Control Lever ( Figure 12 ) all the way back past the Idle
position.
2. Remove the Key for safety. If the Key becomes difficult to remove, apply SAE
30 Oil into the Keyhole.
Engaging the Trimmer Head
1. Bring the Trimmer Head Engage Bar toward you and grip it together with
the Handlebar (non self propel
Figure 13 ) (Self Propel Figure 14 ). Keep
holding the Bar to the Handlebar. The Cutting Cords will rotate and will
continue to rotate until you release the Bar.
Note: Before using your Trimmer for the first time or after you have installed a new
Belt, engage the Trimmer Head Engage Bar 10 times and hold it for 3 seconds each
time. This is required to wear in the Belt to ensure the best grip for trimming.
Stopping the Cords from Spinning
1. Release the Trimmer Head Engage Bar from the Handlebar. The Trimmer
Head will stop spinning while the Engine continues to run.
Figure 14
Handlebar
Trimmer Head
Engage Bar
Trimmer Head
Engage Bar
Figure 13
Handlebar
Key Switch
Throttle
Control
Lever
Figure 12
Recoil Starter
Handle
If the engine fails to start after ten seconds of continuous cranking, turn the key
to the off position and allow the starter motor to cool. Check the cause of hard
starting; See Chapter 5 - Troubleshooting.