Generac Mobile G4-ECO, Руководство пользователя

Страница: 33 / 44

Owner’s Manual for G4-ECO Light Tower 29
Maintenance
Section 4: Maintenance
Emissions Information
For emissions warranty information, refer to the engine
manual supplied with this unit.
Daily Walk-Around Inspection
CAUTION
(000306)
Equipment Damage. Failure to perform a daily
inspection could result in damage to the unit.
Perform a walk-around inspection of the unit every day
before starting the unit. Look for conditions that could
hinder performance or safety, such as (but not limited to):
• Oil/coolant/fuel leakage
• Blocked vents
• Loose/missing hardware
• Loose or broken electrical connections
Inspect the fan belt for cracks, fraying, or stretching. Verify
the belt is properly seated in the pulley grooves. Replace
the belt according to the manufacturer’s recommendations.
General Maintenance
Incorrectly maintained equipment can become a safety
hazard. In order for equipment to operate safely and
correctly over a long period of time, periodic maintenance
and occasional repairs are necessary.
DO NOT perform
routine service (oil and filter changes, cleaning, etc.)
unless all electrical components are shut off.
Regular maintenance will improve performance and
extend engine/equipment life. Generac Mobile Products,
LLC recommends all maintenance work be performed by
a GMP ASD. Regular maintenance, replacement, or
repair of the emissions control devices and systems may
be performed by any repair shop or person of the owner’s
choosing. However, to obtain emissions control warranty
service free of charge, the work must be performed by a
GMP ASD or authorized Mitsubishi engine dealer
depending on the repair. See the emissions warranty.
Preparing for Service
Before servicing the unit, follow the instructions below.
1. Verify the control power switch is OFF.
2. Verify the circuit breakers are OFF.
3. Disconnect the negative (–) terminal on the battery.
4. Attach a “Do Not Start” sign to the control panel to
signify that the unit is being serviced and reduce
the chance of unwanted operation.
Cleaning the Unit
CAUTION
Equipment damage. Never spray water to clean unit.
Do not introduce water into generator widings,
terminals, or fuel system during the cleaning process.
Doing so will result in equipment damage.
(000325a)
Always clean the unit after each use to remove dust,
grease, mud, or spilled fuel or oil. Use soft, clean rags to
wipe the cabinet exterior and control panel. Low-pressure
compressed air (less than 40 psi [276 kPa]) can also be
used to remove dust and debris from the cabinet interior.
This unit contains sensitive electronic components that
can be damaged by high pressure and heat.
DO NOT :
•
wash with a high pressure hose or power washer.
•
wash engine block or fuel tank with a power
washer or steam cleaner. Water may enter the
cabinet and collect in the generator windings or
other electrical parts, causing damage.
Inspecting the Unit
•
If the unit is stored outside, inspect for water inside
the cabinet and generator before each use. If wet,
dry the unit thoroughly before starting.
•
Inspect condition of electrical cords. DO NOT use
the unit if insulation is cut or worn through.
•
Verify winch cables are in good condition and
centered on each pulley. DO NOT use a cable that
is kinked or starting to unravel.
•
Check coolant level daily. See Adding Engine
Coolant .
•
Check oil level daily. See Adding Engine Oil .
•
Check oil level daily. See Adding Engine Oil .
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to purge the fuel lines.
Refer to the engine operator’s manual.
Basic Maintenance Schedule
Refer to the engine manufacturer’s operating manual for
a complete list of maintenance requirements. Failure to
comply with the procedures as described in the engine
operator’s manual will nullify the warranty, decrease
performance, and cause equipment damage or
premature equipment failure. Maintenance records may
be required to complete a warranty request.