PAGE 08 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 09
1
13
13
2
NO
YES
Install the BROWN sensors in the front bumper.
Install the BLUE sensors on the outer edges of the rear bumper.
Install the BLACK sensors on the center of the rear bumper.
BLACK
3
BLUE
BROWN
Snap the bracket (11 or 12) in the hole from the outer part of the bumper.
P
.
osition the plastic brackets so that the connector of the sensor comes out horizontally
11 12
11
7.0 - CONNECTIONS
2
3
1
1
4
3
2
7
6
km/h
+12V
1
1
DATA
5
5
8
MUTE
R
Check the length of the cables before proceeding with the final positioning of the
accessories.
!
!
!
!
!
!
!
!
!
!
!
!
!
Position the main control unit (4) under the driver side dash and the rear unit (7) in the luggage
compartment, both in a dry place, away from eventual water infiltrations and heat sources.
Run the cables along the bumpers and route them to the respective control units.
Fix the buzzer (6) inside the vehicle cabin where you can hear the warning signal. Make sure you
install it in a dry spot, away from eventual water infiltrations and heat sources.
Fix the LED push-button (19) where it can be easily reached.
Plug the LED push-button terminals with the RED, WHITE and BLACK wires to the main control
unit wiring harness connector (5), respectively in positions 18, 19 and 7.
Connect the BLACK-BLUE wire of the control unit wiring harness (5) to the positive under key of the
vehicle and the BROWN wire to the metal frame of the vehicle (ground).
(Optional) connect the BLACK-YELLOW wire to the o
of the vehicle (see chapter
“Setting of Parameters”
).
Plug the buzzer terminals with the YELLOW and BLUE wires to the main control unit wiring harness
connector (5), respectively in positions 15 and 3.
(Optional) connect the GREY-RED wire for the “mute” feature to the corresponding wire of the car
radio preset for this feature.
Plug the terminals with the RED-YELLOW and BROWN wires coming from the rear control unit to
the main control unit wiring harness connector (5), respectively in positions 17 and 5.
Connect the BLACK-BLUE wire of the rear unit wiring harness (8) to the positive of the reverse light
and the BROWN wire to the metal frame of the vehicle (ground).
Plug the connectors of the sensors wiring to the respective connectors of the control unitsI (4 and
7).
dometer signal
for the programming of the pulses
To switch off on ly the back sensors, ground pin 19 inside the wiring connector (8) of the
rear control unit; this connection is useful in case of towing.
Automatic inhibition is also possible if the vehicle and the trailer are electrically
connected and an eventual free position is used to ground pin 19 inside the wiring
connector (8) of the rear control unit.
!
