PAGE 06 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 07
INSTALLER MANUAL
6.0 - INSTALLATION OF SENSORS
Choose the suitable type of
acket and mark the center of the holes to drill.
For brackets “9” drill holes with a 18mm diameter, for brackets “9a” drill holes with a 22mm
diameter and for brackets “10” and “11” drill holes with a 24mm diameter.
Sensors and plastic brackets can be painted to match the color of your bumpers.
plastic br
9
9a
2
2
3
3
1
+
+
8 x
18
22
12
15
9 9a
10
2
3
1
+
24
11
PRIMER
3M
4298UV
250
600
250
100
100
600
320
320
To install the sensors on a metal bumper, you must use appropriate adapters (not
supplied).
!
+18°C
H
H = 400 - 500 mm
H
MAX
H = 500 mm
H = 500 mm
H = 650 mm
H = 650 mm
H = 350 mm
+10°
0°
-10°
12
11
9a
9
3
3
2
2
+10°
+0°
1
1
Before drilling, inspect behind the bumper to check for any possible obstruction such as
iron struts and, in any case, be careful to avoid damaging parts behind the bumper.
!
FRONT
REAR
Remove the protective film from the adhesive (10) and apply it to the bracket (9 or 9a) or proceed
as indicated in the next page to snap the bracket in the hole from the outer part of the bumper.
.
Position the plastic brackets so that the connector of the sensor comes out horizontally
Clean thoroughly the plastic brackets (9 or 9a) and around the holes, apply
“PRIMER” (12), let dry for at least one minute and then proceed as follows.
!
REAR
FRONT
