Gemini 620pd Profiling, Руководство по эксплуатации продукта

Страница: 34 / 72

Gemini Software Installation Gemini Profiling System
0695-SOM-00001, Issue: 03
34
© Tritech International Ltd.
Gemini Software is then used to change the IP address of the Gemini. The third stage
is to reset the IP address of the computer. The final stage is to check the operation
of the Gemini head on the network.
For the correct way to set up the Gemini Profiler network please refer to: Chapter 11,
Network Configuration
For instructions on setting the computer and sonar head IP address please refer to
Appendix A,
Setting the computer IP address in Windows XP
or Appendix B,
Setting
the computer IP address in Windows 7 .
10.3.1. Check the operation of the Gemini sonar
If the correct changes have been made to the Gemini Sonar it should now show
as connected in the Gemini Software. If nothing is displayed, check that all values
entered were correct and it may be necessary to rerun the Gemini Software to establish
a link. The Gemini Software retains its settings between runs, and so all the values
which were used whilst the Gemini was programmed will be retained.
When the Gemini Software is started, select the
Advanced
tab to show details of the
connected Gemini. If the head is able to communicate, it will be listed in the status
window and automatically go online after five seconds.