Gema MultiStar CG10, Инструкция по эксплуатации и список запасных частей

Страница: 43 / 64

Rev. 00 08/17
MultiStar CG10 Operation

43
3. Press the key
The display switches to the correction factor level. The correction
factor number is shown in the display A1 with a C placed in front
4. Check the correction value for minimum powder output C0 on the A2
display, and set it to 1.8 (Nm³/h) with the T3/T4 keys if necessary
5. Check the correction value for maximum powder output C1 on the
A2 display, and set it to 100 (%) if necessary
For the next steps a measuring bag is necessary, for weighing
the powder output.
– Do not forget to note the dead weight of the measuring bag.
6. Put the measuring bag over the gun nozzle and fasten it. Switch on
the gun for 60 seconds
7. After this time has elapsed, switch off the gun, remove the
measuring bag and weigh it. The powder output should be between
10-15 gr
8. If no powder is expelled from the gun, return to the system
parameter mode and increase the minimum powder output value
C0
(range 0.5-3.0 Nm³/h)
9. If too much powder is expelled from the gun, return to the system
parameter mode and decrease the minimum powder output value
C0 (range 0.5-3.0 Nm³/h)
10. Repeat steps 6 and 7, until the powder output amounts to 10-15 g.
Annotate the adjusted minimum powder output value C0 in the table
Exit the system parameter mode by pressing the key.
Powder hose correction
– procedure
1. Set the powder output value to 80 (%) on the A1 display
2. Put the measuring bag over the gun nozzle and fasten it. Switch on
the gun for 60 seconds
3. Switch off the gun after 60 seconds, remove the measuring bag and
weigh it
4. Annotate the powder output in g/min in the table
Calculate the powder output correction according to following formula:
C1 (%) =
smallest powder output
x 100
measured powder output
5. Annotate the calculated values ( C1 ) for each individual gun in the
table and enter the values to the control unit (therefore, repeat the
steps 2 and 3)