Chapter 3 - Setup
43
© 2018 Geist
GM1196 R-Series v5 Instruction Manual
NOTE
Clicking this symbol does not clear the Warning or Alarm Event,
it just stops the notifications from repeating and removes it from
the active Event list.
4. The actual conditions for the various Alarms & Warnings settings are shown here.
Alarms & Warnings Configuration
To add a new Alarm or Warning Event:
1. Click the Add/Modify Alarms & Warnings button:
Figure 3-9
Add/Modify Alarms & Warnings Page
2. Set the desired conditions for this Event as follows:
a. Select the
Name
of the phase or circuit you wish to set an Event on.
b. Select the measurement (current, voltage, etc.) you want to
Trigger
the Event.
c. Set the
Severity
level ("Warning", or "Alarm") for this Event.
d. Select the threshold
Type
, "Status" (trips if device status changes), "high" (trips if
the measurement goes above the threshold) or "low" (trips if the measurement goes
below the threshold).
Содержание RCM-O
Страница 1: ...R Series v5 Instruction Manual geistglobal com...
Страница 82: ...Thank You For Purchasing Geist geistglobal com...
