R-Series v5 Instruction Manual
30
© 2018 Geist
GM1196 R-Series v5 Instruction Manual
than one TCP/IP entry, as in the example above, the computer may be configured for IPv6
support as well as IPv4; make sure to select the entry for the IPv4 protocol. Write down
the current NIC card settings so you can restore them to normal after you have completed
the setup procedure.
Figure 2-16 Internet Protocol Version 4
Choose the
Use the following IP address
option, then set
IP address
to 192.168.123.1
and
Subnet Mask
to 255.255.255.0. For this initial setup,
Default Gateway
and the
DNS
Server
entries can be left blank. Select
OK
, then
OK
again to close both the
Internet
Protocol Properties
and
Local Properties
windows.
Once the NIC settings are configured properly, you should be able to access the unit by
typing http://192.168.123.123 into the address bar of your web browser. If you are setting
up the unit for the first time, or if the unit has been reset back to factory defaults via the
network-reset button, the unit will require you to create an Admin account and password
before you can proceed.
Once you have created an Admin account and have logged into it, the unit's default
Sensors
page should come up by default. Navigate to the
System
tab, then the
Network
Содержание RCM-O
Страница 1: ...R Series v5 Instruction Manual geistglobal com...
Страница 82: ...Thank You For Purchasing Geist geistglobal com...
