Gehl 383Z, Руководство оператора, Страница: 89 / 112

Printed in U.S.A. 4-15 918196/EP0913
Bleed air from the fuel system according to the follow-
ing steps:
1. Fill the fuel tank.
2. Make sure that the valve on the water separator
valve (1, Figure 4-9) is in the “ON” position.
Figure 4-9 Fuel Shut-off Valve in “ON” Posi-
tion
3. Turn the ignition key to the “I” (ON) position.
4. Wait about five minutes while the fuel system
bleeds itself.
5. Start the engine.
If the engine runs smoothly and then stops, or if it does
not run smoothly, switch off the engine and bleed the
system again as described in this procedure. If the
engine still does not run smoothly, contact your dealer.
Cooling System
Checking Coolant Level
Note: The engine must be cold.
1. Press the engine cover release button and raise the
engine cover.
2. Check the coolant level in the expansion reservoir.
If the coolant level is low (2, Figure 4-10), remove
the reservoir cap and overflow tube.
3. Fill reservoir to FULL line (1). Refer to
“Fluid
Capacities/Lubricants
” on page 1-4 for the correct
coolant type and to
“Coolant Compound Table
” on
page 1-8 for the correct coolant mixture. Replace
the reservoir cap.
Figure 4-10 Coolant Expansion Reservoir
1
1
2