G901X STEP PULSE MULTIPLIER
REV 2: March 8, 2011
PLEASE NOTE: The four pins closest to the optoisolator are used as placeholders for extra jumpers; these
do not connect to anything on the G901X or the drive it is plugging into. It is recommended to use small needle-
nose pliers or tweezers to move the jumpers on the internal headers.
REPLACING THE COVER:
1.)
Make sure the LED is vertical relative to the drive printed circuit board.
2.)
Slide the cover forward over the drive while lifting the back of the cover.
3.)
When the cover is fully forward, look to see the LED is aligned with the hole.
4.)
Gently press the cover down, making sure the LED moves into the hole.
5.)
Replace the screws on the bottom of the drive.
G901X LAYOUT AND DIMENSIONS
