Geberit 115.817.11.5, Руководство по обслуживанию

Страница: 12 / 24

EN
12
D64372-001 © 12-2013
966.444.00.0 (00)
Maintenance
Troubleshooting
Cleaning the cover plate
Malfunction Cause Rectification
Flush is not actuated Water supply valve is closed
`
Open the water supply valve
No pressure in the water net
`
Restore the water pressure
The basket filter is blocked
`
Clean or replace the basket filter
No mains current
`
Check power supply
The plug connections are
disconnected or damaged
`
Re-establish the plug
connections
The battery capacity is low
(battery-operated controls)
`
Replace batteries
The solenoid valve is defective
`
Replace the solenoid valve
The power supply unit is defective
(mains-operated controls)
`
Replace the power supply unit
The sensor window is dirty or
scratched
`
Clean or replace sensor window
Water is running continuously into
the urinal ceramic The sensor electronics are
defective
`
Replace the sensor electronics
The solenoid valve is defective
`
Replace the solenoid valve
Incorrect flushes (too soon, too
late, unwanted) The sensor window is dirty or
scratched
`
Clean or replace sensor window
The sensor electronics are
affected by influences in the room
(mirrors, metal surfaces, etc. on
the wall opposite)
`
Contact Geberit customer
service
The urinal ceramic is not being
flushed out sufficiently The flow rate is too low
`
Readjust the throttle
The flush water is splashing out
from the urinal ceramic The flow rate is too high
`
Mount a flow limiter. Flow
limiters are available as
accessories
(article number 242.484.00.1)
`
Readjust the throttle
CAUTION
Aggressive and scouring cleaning agents can damage the surface.
`
Never use aggressive cleaning agents that contain chlorine or are acidic, abrasive or corrosive.
`
Clean the cover plate with mild cleaning agents and water.
`
Use a soft cloth.
Geberit recommends the GeberitAquaClean cleaning set (article number 242.547.00.1) for cleaning
the cover plate.