– 31 –
(Continued next page)
Fill Funnel
The fi ll funnel is mounted on the left side of the tub
and allows water to be supplied to the wash and
rinse cycles.
To remove the fi ll funnel:
1. Access
the
fi ll funnel by carefully pulling the
dishwasher out from its installation.
2. Pull
the
fi ll hose out of the fi ll funnel.
Note: When inserting the fi ll hose, place it 1
1
/
2
inches below the fi ll funnel rim.
Fill Funnel
Hose
3. Rotate
the
fi ll funnel clockwise and remove it.
Caution: To prevent water leakage, assure the
O-ring is in place before installing the fi ll funnel.
O-ring
Water Inlet Valve
The water inlet valve is electronically controlled and
solenoid-operated. The fl ow of water is controlled by
a rubber fl ow washer capable of maintaining a fl ow
rate of 1.1-1.3 gallons per minute with incoming
water pressure of 20 to 120 PSI. The water valve is
attached to a bracket located on the left side of the
front brace.
The water valve is energized for
approximately 21-
62 seconds during each fi ll. See the cycle chart for
specifi c times during cycles. (See
Cycle Chart
.)
The water valve has an approximate resistance
value of 1 K
Operation of the water valve can be checked by
using the service test mode. (See
Service Test Mode
.)
To remove the water valve:
1. Remove two 1/4-in. hex-head screws and the
access panel.
Содержание PermaTuf GLD28**V
Страница 8: ...8 and closing Continued next page...
