GEA Bock HGX2 CO2 T Series, Инструкция по ремонту

Страница: 13 / 24

09
430
-08
.2
01
6-
Gb
13
Assembly instructions for HGX46 CO
2
T up to design key A053
¾
Insert the feather key.
¾
Align the stator so that the cable harness is positioned upwards and the feather key is aligned with the groove of the
stator.
X
Do not damage any cables and components . Push the stator with the cables leading, into the motor housing until
the stop. At the same time, carefully pull the cables upwards through the terminal board opening.
¾
For the threaded pin (2) (M8x16), a countersink has to be provided.
X
For this purpose use a drill with Ø 6.8 mm and a drill tip of 90° .
¾
Bore a hole into the stator by observing the dimension Y = 62,4
-0,5
mm , but only use a drill with cone tip.
X
Carefully remove the chips
(e.g. with a vacuum cleaner)
.
WARNING
The heavy weight of the stator can potentially be dangerous; risk of falling, danger of crushing.
X
Use a suitable hoist for the removal.
X
Note the direction of the feather key — stator.
You must align the parts in order to install them.
Y
¾
For clamping the feather key to the stator, a threaded pin (1) (M8x20) without tip is used (see figure).
¾
Screw in the new threaded pins, see page 15.
Threaded pin (2) for stator protection
Threaded pin (1) for clamping the feather key
max.
75kg
Assembly