– 28 –
Lid
Lid Removal
1. Close the lid and remove the rear component
cover.
2. Remove the two hinge springs using pliers to
pull them out from spring retainers.
3. Open the lid and remove the two hinge pins by
pushing down on the tab of the pin and then
slide the pin out.
Top Cover
Top Cover Removal
1. Remove the front control panel, machine control
and UI boards, rear component cover, water
valve/dispenser assembly, and pressure sensor.
NOTE: The screws that secure the front control
panel and the rear component cover are the
only screws that secure the top cover to the
cabinet.
2. Disconnect and remove the power cord
from the underside of the top cover. This is
accomplished by disconnecting the black and
white connecters under the back cover and
removing the ground screw shown.
3. Release the clips that hold the power cord in
place. Pull the cord loose.
