GE TMO2D, Руководство пользователя

Страница: 36 / 102

Chapter 4. Basic Programming
28 TMO2D Digital Display User’s Manual
4.4.7 Set Communications? (cont.)
Note:
The baud rate can be changed using a terminal connected to the RS-232C port. However, this is not
recommended, as the TMO2D will immediately change to the new baud rate. Display and keyboard operation
will not be correct until the baud rate of the terminal is changed to match the new baud rate set in the TMO2D.
Update Rate: This option is used to change the interval at which data goes to the serial port. The current data interval
will appear in brackets, and users can enter a new data interval.
Data intervals range from 0 to 300 seconds. A data rate of zero will prevent data from passing to the serial port.
SELECT BAUD RATE
300 baud?
Press [YES] to select the desired baud rate and exit.
SET COMMUNICATIONS
Set Baud Rate?
Press [NO] to proceed to the next submenu.
SET COMMUNICATIONS
Set Update Rate?
Press [YES] to set the update rate.
SET COMMUNICATIONS
Data Interval [X]: 180
For example, enter 1, 8 and 0 for a 180 sec (3 min) interval. (The X represents the
previously entered data interval.).
SET COMMUNICATIONS
Data Interval [180]:
Press [YES] to confirm the entry, and [YES] again to exit.
SET COMMUNICATIONS
Set Update Rate? Press [NO] to proceed to the next submenu.
SET COMMUNICATIONS
Set Time Stamp?
Press [YES] to determine if you want the record printed with a time stamp. If you
select this option, the date and time for each data point will go to the serial port.
Print Time Stamp:
YES [NO]
Use the [NO] or arrow keys to indicate whether a time stamp will be printed. Then
press [YES] to confirm the selection.
SET COMMUNICATIONS
Set Time Stamp?
Press [NO] to proceed to the next submenu.
SET COMMUNICATIONS
Done?
Press [YES] to return to the main Setup Menu.
SETUP Menu
Set Communications?
Press [NO] to proceed to the next submenu.