GE TELUM ASLP11, Справочное руководство

Страница: 33 / 64

Table 1: Bootup timing
Time after releasing
PCI reset POST
CODE Status LED Comment
1 µs D0 Red 1Hz blinking
726 ms AC Orange 1Hz blinking All memory is initialized
3.9 s D4
8.4 s D6
12.2 s D7
12.3 s 03 Green 1 Hz blinking Keyboard enabled *1
12.7 s 4013 Green 2 Hz blinking
15.2 s 202A Video Bios is started
16.9 s 3C Green 3 Hz blinking
17.2 s 78 Starting external BIOS
17.2 s 8C Green 4 Hz blinking
17.3 s 00 Green steady on Try booting from mass
storage
*1 now is the right point to press DEL if you want to go to BIOS SETUP
Setup
Whenever you want to work manually at the ASLP11, you need some sort of
console connection. Either you use the optional serial port or the planned
console rerouting via Ethernet or you have to connect a graphics card to the
PCI-Express port.
If you want to enter the BIOS Setup, you have to press the keyboard ‘DEL’ key
at the right moment. Especially when using a slow starting monitor it might be
too late to wait for the CRT to show the message ‘Press DEL to enter Setup’.
Better look for the LED and press ‘DEL’ as soon as the LED changes from
orange to green blinking. When you are using add-on cards with external BIOS,
you can hit the DEL key while their BIOS runs (i.e. SCSI BIOS device scan).
When you miss the right moment to press the DEL key, please use the reset
button on the front panel to restart the power up sequence or switch off the
power supply for a few seconds and restart it. With the current BIOS pressing
the Ctrl-Alt-Del key combination at this boot-moment will result in switching
to the next bootable device and try to boot from this. This feature cannot be
disabled within Setup.
Hot Swap
The ASLP11 family supports full hot swap according to AMC.0. This includes
all hardware functionality to detect other bus cards or devices to be plugged in
or removed while the system is running under power. Also the ASLP11 can be
hot-plugged to a running system or be removed from it.
The necessary software/driver and operating system handling is not done within
the BIOS of the ASLP11, because all the tasks to recognize new inserted
boards, to re-enumerate the PCI memory space while other cards/transfers are
GE Intelligent Platforms – ASLP11 Hardware Reference Manual, Third Edition Page 33