GPS Grandmaster Clock
48
RT430-TM-EN-5
IP Address
192.168.0.199
Network mask
255.255.255.0
Configure manually the computer local network connection to:
TABLE 31: Computer IP address, broadcast, and network mask.
IP Address
192.168.0.190
Network mask
255.255.255.0
If the unit is not using factory default settings, see
Chapter 5
for instructions to visualize the current IP
address via local interface.
After connecting the unit to the computer, see
section 3.6
for details about accessing the unit.
To check if the unit is accessible, it is possible connect a cross-over network cable to the computer from a
terminal using command line, and run a ping command to the IP address of the unit.
3.5
Communication via Ethernet network
For communication via E
THERNET
port, connect one of the ports to the same network the computer is
connected, using a pin-to-pin cable, as shown in
Figure 25: Architecture of communication via Ethernet port
In communication via network, it is necessary the unit and the computer to be in the same local subnet. It is
recommended the
E
THERNET
port of the unit to be configured by a user to be compatible with a local network,
i.e, the IP address, network mask, gateway, DNS and broadcast should be compatible with the network the
computer is connected to.
