– 21 –
Cover/Lid Assembly
The cover/lid assembly is fastened at the front by
2 screws, on the sides by 2 metal catches, and at
the back by 3 locking tabs that protrude from the
bottom of the control panel.
Note:
Do not allow lid to swing open when cover/lid
assembly is removed. Damage may result.
To remove the cover/lid assembly:
Remove the front panel. (See
Front Panel
).
Remove the lid switch. (See
Lid Switch
.)
Remove the two ¼-in. hex screws securing the
front of the cover/lid assembly to the cabinet.
1.
2.
3.
Pull the top cover toward you while lifting up the
front edge to release the side catches. Slide the
top cover to the left to release from the 3 tabs.
4.
Front Panel
The front panel is a removable, galvanized sheet
metal section. The front panel is fastened at the
top by 2 metal spring clips, and at the bottom by 2
metal tabs which protrude from the base of the unit
into slots in the panel bottom.
Most major mechanical components can be
accessed by removing the front panel.
To remove the front panel:
Locate 2 spring clips between the top cover and
front panel by aligning a putty knife with left or
right edge of lid.
Insert the putty knife and push forward to
release clips.
1.
2.
Rotate the front panel forward and lift off the
bottom tabs.
3.
