– 15 –
Washer Components
WARNING:
Sharp edges may be exposed when
servicing. Use caution to avoid injury. Wear Kevlar
gloves or equivalent protection.
Shipping Rod
There is a new location for the shipping rod. The rod
is inserted and removed through a hole located on
the lower right side of the cabinet and now passes
in front of the drain pump.
The shipping rod passes through the chassis rod
brackets and the platform brackets.
Leveling Legs
The front legs are screw type and are adjusted
by turning the legs counterclockwise to increase
height. The rear leveling legs are contained in an
assembly and will level the rear of the washer left to
right.
To level the washer, tilt the washer forward to lift the
rear legs off the floor, then gently set it back down.
Adjust the front leveling legs to level the washer
front to back and left to right across the front.
Rod Inlet Hole
Chassis Rod
Bracket
Chassis Rod
Bracket
Agitator
The agitator is a dual-action ratcheting type, which
sets on an air bell coupling. Remove the agitator
by grasping the bottom and sharply pulling up. To
protect from back injury, use agitator strap, part
number WX5X1326 or equivalent.
To align the agitator for reassembly, match the
grooves in the air bell to the grooves inside the
agitator. The fins on the outside of the agitator
are aligned with the grooves on the inside of the
agitator. To remove the air bell coupling, remove the
7
/
16
-in. bolt and lift coupling off the shaft.
Platform Brackets
Shipping Rod
