– 36 –
Knob Position Function
Description
Position 0
LED Check
Lights all LEDs on display.
Position 1
Model Code
Factory code setting for main control.
Position 2*
(Rinse LED On)
EEPROM Error
Control memory check. Error requires main control replacement.
Position 2*
(Wash LED On)
Thermistor Error
At the start of each wash cycle (except in the tap cold temperature
setting), the control will check whether the sensor is open or shorted.
If open or shorted, the control will complete the wash cycle without
relying on temperature feedback. In determining an open or shorted
thermistor, the control looks for an out of range reading, which is 10K at
the lower limit and 120K at the upper limit.
Position 2*
(Soak LED On)
Slow Pump Error
If the pressure switch does not reset (closed/empty tub) within 3
minutes of the control starting the drain pump, the slow pump error will
be recorded.
Position 3*
(Rinse LED On)
No Fill Error
If the tub takes longer than 20 minutes to fill, the no fill error will be
recorded.
Position 3*
(Wash LED On)
No Pump Error
If the pump detection circuit indicates no water is being pumped while
the pump is energized and the pressure switch is open (water in tub), the
no pump error will be recorded. The control uses current amplitude of
the drain pump motor to determine whether water is being pumped.
Position 3*
(Soak LED On)
Push Button Error
If any button is closed for 1 minute or longer, the push-button error
code will be recorded.
Positions 4 - 9
Activates the listed
component.
Position 4 = Hot water valve active
Position 5 = Cold water valve active
Position 6 = Slow agitate (dry)**
Position 7 = Fast agitate (dry)**
Position 8 = Pump
Position 9 = Spin
Position 10
Pump Time
Hold Start/Pause button for 3 seconds to toggle setting. Changing the
setting from 3 ft. to 8 ft. adds 30 seconds to the drain pump out time
before each spin cycle begins. Default pump out is 3 minutes. Changing
to 8ft changes the pump out time to 3 ½ minutes.
NOTE:
* To clear any recorded errors in Positions 2 or 3, press the Start/Pause button while in the appropriate position.
** Depress and hold the Start/Pause button for 3 seconds for wet agitation. Energizes the water valves based on
temperature control setting.
