GE Profile PDW8680N, Руководство по установке

Страница: 8 / 17

7
Installation Instructions
STEP 8 POSITION WATER LINE AND
HOUSE WIRING
• Position water supply
line and house wiring
on the floor of the
opening to avoid
interference with
base of dishwasher
and components
under dishwasher.
Figure O
• Push hose over the drain outlet on the back side of the
dishwasher. See Figure P. Push the hose over the outlet and
against the shoulder stop.
• Tighten the hose clamp with a 1/4" nut driver.
Figure P
Figure Q
• Position the dishwasher in front of the opening. Insert drain
hose into the cabinet side. If power cord is used, guide the
end through a separate hole.
�����
����
�����
������
�� �� ��
��
��
���������
����������
���������
�����
����
�����
������
�����
����
����������
�������
���������
STEP 9 INSTALL DRAIN HOSE, GUIDE
THROUGH CABINET
• Stand the dishwasher upright.
• Get the drain hose set aside earlier and remove hose clamp
attached to hose.
Be careful not to damage
the drain hose.
• Slip the hose clamp
over the pump end
of the hose.
Figure R
STEP 10 SLIDE DISHWASHER PARTIALLY
INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a time.
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher is a few
inches forward of adjacent cabinets.
• Make sure drain hose is not kinked under the dishwasher and
there is no interference with the water line and wiring or any
other component.
�������������������
���������������������
�������������������
������������������������
���������
����������
�����
������
����
�����
�����
����
Figure N
• Do not over tighten the 90° elbow, water valve bracket could
bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
STEP 7 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
�������������������
���
�����
������
���������
����
����
�����������
�������
����������