– 62 –
Remove the six ¼-in. hex-head screws that
5.
attach the top brace to the range. Remove the
brace.
Upper Oven Door Lock Assembly
To remove the upper oven door lock assembly:
Note:
If only the lock motor and switch assembly
and/or cam has failed, it may not be necessary to
remove the door lock assembly from the range. It
is possible to transfer these parts from a new door
lock assembly. Verify proper operation of the lock
assembly after transferring these parts.
Remove the rear cover. (See
1.
Rear Cover Removal
.)
Open the upper oven door and remove the two
2.
¼-in. hex-head screws that hold the front of the
cooktop to the top brace.
Raise and support the cooktop.
3.
Caution:
To prevent damage to the cooktop or the
control panel, do not raise the cooktop more than
45 degrees.
Remove the ¼-in. hex-head ground screw,
4.
ground wire, and the wire retainer from the
mounting plate.
Wire Retainer
Remove the two T-15 Torx screws
6.
(
fi
rst 300 units
produced used ¼-in. hex-head screws)
that
attach the front of the mounting plate to the
frame.
Caution
: It is possible to reconnect the switch wiring
incorrectly to the lock assembly. When reconnecting
the wiring, make sure it is properly connected to the
lock assembly before turning the power back on.
Disconnect the lock motor wire harness and
7.
mark and disconnect the switch assembly wire
harnesses.
Remove the ¼-in. hex-head screw that attaches
8.
the lock assembly to the rear of the range.
Switch Assembly
Wire Harness
Lock Motor
Wire Harness
(
Continued next page
)
Ground Wire
