– 37 –
Lift door up until the hinge arm is clear of the
5.
slot.
To replace the lower door:
Firmly grasp both sides of the door at the top.
1.
With the door at the same angle as the removal
position, seat the indentation of the hinge arm
into the bottom edge of the hinge slot.
7X]VT0a\
1^cc^\
4SVT
^UB[^c
8]ST]cPcX^]
Fully open the door.
2.
Push the hinge locks up against the front frame
3.
of the oven cavity, to the locked position.
Close the oven door.
4.
To remove the outer door assembly:
Remove the door. (See previous page.)
1.
Place the door assembly, gasket side up, on a
2.
protective surface.
Remove the 4 Phillips-head screws from the
3.
bottom of the outer door assembly.
Remove the 4 Phillips-head screws (2 on each
4.
side) from the outer door assembly.
Note:
The inner door assembly is heavier than the
outer door assembly.
Separate the inner door assembly from the
5.
outer door assembly.
Remove the four ¼-in. hex-head screws
6.
that hold the door handle to the outer door
assembly.
Caution:
Care must be taken if reinstalling the door
•
handle. Be sure that each handle cushion is
placed between the glass and the bracket.
Overtightening screws can damage handle/
•
glass. Hand-tighten screws and make sure
handle
fi
ts snugly to door panel. (
Do not use
electric driver
.)
