BEFORE YOU BEGIN
Installation
Dryer
Instructions
PTDN800, PTDN805, PTDS850, and PTDS855
14
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
In Canada, call 1.800.561.3344, or visit geappliances.ca
FOR YOUR SAFETY:
WARNING
•
Use only rigid metal or flexible metal 4-inch
diameter ductwork for exhausting to the
outdoors. Never use plastic or other combustible
easy-to-puncture ductwork.
•
This appliance must be properly grounded and
installed as described in these instructions.
•
Do not install or store appliance in an area where
it will be exposed to water and/or weather.
•
The National Fuel Gas Code restricts installations
of gas appliances in garages. They must be 18
inches off the ground and protected by a barrier
from vehicles.
•
Install the dryer where the temperature is above
50°F for satisfactory operation of the dryer
control system.
FOR GAS MODELS ONLY:
NOTE: Installation and service of this dryer must
be performed by a qualified installer, service
agency or the gas supplier.
In the Commonwealth of Massachusetts:
• This product must be installed by
a licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be T-handle-type.
• A flexible gas connector, when used,
must not exceed 3 feet.
Read these instructions completely and carefully.
•
IMPORTANT
–
Save these instructions for local
electrical inspector’s use.
•
IMPORTANT
–
Observe all governing codes and
ordinances.
•
Install the clothes dryer according to the manufacturer’s
instructions and local codes.
• Note to Installer –
Be sure to leave these instructions
with the Consumer.
• Note to Consumer –
Keep these instructions for future
reference.
•
Clothes dryer installation must be performed by a
qualified installer.
•
This dryer
must
be exhausted to the outdoors.
•
Before the old dryer is removed from service or
discarded, remove the dryer door.
•
Service information and the wiring diagram are located
in the control console.
•
Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Warranty
.
•
Install the dryer where the temperature is above 50°F
for satisfactory operation of the dryer control system.
• Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
