GE NetworX V3, Руководство по установке

Страница: 98 / 286

NetworX Version 3 Installation Manual
98
LOCATION 10 - EVENTS REPORTED TO PHONE N° 2 (2 segments of feature selection data)
Segment 1 1 = Alarms
2 = Opening and closings
3 = Zone bypass and bypass restores
4 = Zone trouble and trouble restores
5 = Power fail (AC failure), low battery, power restore (AC restore) , and low
battery restore
6 = Bell cut, bell cut restore, telephone line restore
7 = Test reports
8 = Start and end programming, download complete and log full
Segment 2 1 = Zone and box tamper
2 = Auxiliary power overcurrent, and restore
3 = Wireless sensor missing and restore
4 = Wireless sensor low battery and restore
5 = Expander trouble and restore (keypads are considered as expanders)
6 = Fail to communicate
7 = Alarm restore
8 = Tamper restore
LOCATION 11 - PARTITIONS REPORTED TO PHONE N° 2 (1 segment, feature selection data)
Location 11 is used when events to be reported to a phone number are based on the partition,
regardless of the event. If this location is used, location 10 should be “0”.
Segment 1 1 = Partition 1
2 = Partition 2
3 = Partition 3
4 = Partition 4
Telephone number 3
LOCATION 12 - PROGRAMMING PHONE N° 3 (20 segments, numerical data)
Phone N°3 is programmed in location 12. A “14” indicates the end of the phone number. Delays of
four seconds can be programmed at any point in the phone number by programming a “13” in the
appropriate segment. The system will always wait for a dial tone unless the first digit of the phone
number is a “13”; in this case, it will only delay. Tone (DTMF) dialling is default. If you want pulse
tone dialling, program a “15” in the segment where pulse dialling should begin. If the entire number
should be pulse dialling, program a “15” in the first segment. Program an “11” for a “*”, and a “12”
for a “#”.
Note: A zero is programmed as a “0”.