GE NetworX V3, Руководство по установке

Страница: 45 / 286

NetworX Version 3 Installation Manual
45
Word library
The word library is a predefined collection of words that speeds up text editing. As you type a
character, the keypad automatically displays a matching word. The word library is enabled by
default. For a complete list of words in the word library, see
Appendix 6: Word library words .
•
To accept the word, press F5 . The cursor moves to the end of the new word and you
can continue to enter text.
•
To create a shortened version of the word, press F5 to accept the word. The cursor
moves to the end of the new word. Move the cursor to the first unnecessary character
and press #
¾ to delete the end of the word.
•
To reject the word, continue entering text as normal.
•
Press the
½¾
keys to scroll through the list of word library words.
To disable the word library:
1.
Navigate with the
½¾
keys to Word Library and press OK.
2.
The current state of the word library is displayed. In this case, it is enabled.
3.
Use the ½¾ keys to change the state to disabled and press OK.
4.
The keypad beeps once to accept the change and returns to Word Library .
Note: In case of wireless keypads, user texts (user names, zone names, etc.) are copied from the keypad to the RF
receiver first and then sent to the target keypad (or one-by-one to consecutive keypads). It takes some time,
and can sporadically affect other communication with the source/target keypad, including false state of the
range indicator and/or status icons. It is a temporary state, and after copying is finished all icons will again
show correct state of the system.
Due to the large number of data being transmitted, it is recommended that no other operations are
performed during copying as it can affect operation of the system. It applies in particular to the wireless
keypads.
Guidelines for location-based programming
You can switch to location-based programming mode. This mode uses devices, locations and
segments. Please notice, that the recommended programming method is to use the menu structure
rather than devices and locations. In order to use location-based programming, follow the procedure
below:
1.
Press OK and type your installer code (factory default is 9713). If the installer code is
valid, the OK=LOC
½¾
=MENU screen displays.
2.
At the OK=LOC prompt press OK . The “Enter the device address” screen displays. You
are now in the program mode and ready to select the module to program.
Note: It is impossible to enter program mode if any partition - or the system - is armed.
Selecting the module to program
Since all the modules connected to the NetworX system are programmed through the keypad, the
module you are programming should be the first entry. For example, to program the NetworX control
panel, enter [0]-[#]. The [0] is the module number of the control panel and the [#] is the entry key.
Other module entry numbers can be found in the corresponding manuals or in
Appendix 2: Overview