GE NetworX NX-1500E, Руководство пользователя

Страница: 14 / 23

ADDING AND CHANGING USER CODES
Your system must be Disarmed to change user codes.
Step 1 Press [
r
]-[5]-[“Master Arm/Disarm” Code].
NOTE: For partitioned systems, someone changing the code of
another person must have access to all or more partitions
than the user being changed.
Step 2 The ready light will flash.
Step 3 Enter the 2 digit “user number” (always enter 2 digit such as [0]-
[3] for user 3, or [5]-[2] for user 52).
Step 4 The zone lights will illuminate specifying the first digit of the “user
code”. (Lights 1-8 on = code is blank, lights 1-8 off = “0”, lights 1
and 8 = “9”).
NOTE: To delete a user code, enter [
r
]-[
r
]-[
r
]-[
r
] for a 4-digit code, or
[
r
]-[
r
]-[
r
]-[
r
]-[
r
]-[
r
] for a 6-digit code.
Step 5 The ready light will flash indicating you are back at Step 2 above. If
the code is rejected, the sounder will beep 3 times.
Step 6 If another “user code” needs to be programmed, return to Step 3.
Step 7 Press the [#] key while the ready light is flashing to exit the User
Code Programming Mode.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user
codes before assigning authority levels.
Step 1 Press [
r
]-[6]-[“Master Arm/Disarm Code”].
NOTE: Someone changing the authority of another person can only
add or remove partition authorization for partitions to which
they have access.
Step 2 The ready light will flash.
Step 3 Enter the 2 digit “user number” to be assigned authority (The ready
light is constant and the instant light will flash).
Step 4 Lights illuminated indicate the authority levels assigned to this
code. An explanation of the lights is listed in the following table.
Page 13