7
Installation Instructions
STEP 5 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to the
Owner’s Manual for more information. Allow 12–24
hours for temperature to stabilize.
NOTE:
The Outdoor/Indoor Refrigerator operates very
quietly. You may not notice the unit running, and when
first installed, the fans and motor may not come on
immediately—this is normal. If the display is lit and
the light is working, the unit is operating.
STEP 3 CONNECT POWER
• If the refrigerator is used outdoors, plug the power cord
into a GFCI receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
• The interior fan runs at all times except when the
door is open. See the the Owner’s Manual for further
explanation.
STEP 4 SLIDE PRODUCT INTO
THE CUTOUT
CAUTION:
Do not push against the door
with your knees. Do not push or lift the unit by the door
handle. Damage may occur!
ATTENTION :
Ne poussez jamais la
porte avec vos genoux. Ne poussez jamais votre appareil
ou ne le soulevez jamais par la poignée de porte.
Vous pouvez l’endommager.
• Open the door and gently push the unit back into the
opening with your hands against the sides. Be careful
not to entangle power cord.
• In a standard 24"
opening, the door will protrude
1-1/2"
forward of the surrounding cabinets.
• Check again to be sure the unit is level.
• If the unit is installed under a countertop, adjust the
leveling legs until the unit is resting firmly against
the bottom of the countertop.
• If alignment with adjacent cabinetry is an issue,
use a shim to secure the unit against the underside
of the countertop.
• Test the door swing. Carefully open and close the
door. The door should not rub or catch on adjacent
cabinetry. Notify the installer if the door makes
contact with cabinetry.
STEP 2 LEVEL
• Use an adjustable wrench to turn and raise or lower
the leveling legs.
• Measure floor to countertop height inside the opening.
Adjust leveling legs until the product is approximately
1/8"
less than countertop height.
INSTALLATION TIP:
Measure floor to underside of countertop inside
the opening.
• If the room floor is higher than the floor inside the
opening, adjust the rear leveling legs to approximately
1/8"
less than the opening height. Screw front leveling
legs all the way in to shorten the height at the front.
This will allow you to slightly tip the unit into the
opening. Once the unit is in the correct position,
the front legs can be adjusted to level the product.
Turn Right to Lower
Turn Left to Raise
STAINING WOOD DRAWER FRONTS
The drawer fronts are unfinished cherry wood. During
use, oil from hands may accumulate and stain the wood.
• The drawer fronts may be stained and sealed to match
adjacent cabinetry.
• Apply the stain and sealer according to the
manufacturer’s instructions. To avoid unpleasant odor,
keep the door open to ventilate and allow the stain/
sealer to dry completely before using the product.
