5
Design Guide
CAUTION:
Underside edges of the
stainless steel canopy
top may be sharp. Wear
heavy-duty work gloves
when moving the top.
(A)
(B)
(C)
PREPARATION FOR BUILT-IN
UNDER-COUNTER INSTALLATIONS ONLY
The top canopy may be removed when installing under
a countertop.
• Remove the three screws from the back of the top
canopy (A).
• Using heavy-duty work gloves, lift up on the top
canopy back (B) and slide it forward until it unlatches
from the unit (C).
• Lift the top canopy up and off of the unit.
NOTE:
Keep the top canopy and screws for future
free-standing installations.
NOTE:
When installing the unit in a free-standing
configuration, the top canopy must be left in place.
•
If replacing the top canopy make sure the three latches
in the front slide into the front lip of the canopy before
pushing the canopy to the rear of the unit.
PRODUCT CLEARANCES AND
LOCATION REQUIREMENTS
The Outdoor/Indoor Refrigerator is factory set for
a 110° door swing.
When installed in a corner:
• Allow 5-1/4"
min. clearance on the
hinge side
for
the 90° door swing and to allow racks to slide out.
• Allow 15"
minimum clearance on the
hinge side
for a full 110° door swing.
•
Test the door swing. Carefully open and close the door.
Adjust if the door makes contact with cabinetry.
502Dia21
15" Minimum
to Wall
110˚
110˚
Door
Swing
21-5/8"
23-5/8"
5-1/4" Minimum
to Wall
90˚
90˚
Door
Swing
