INSTALLATION INSTRUCTIONS
Do not remove the wood base until you are
ready to install the dishwasher. The dishwasher
will tip over when the door is opened.
CAUTION
Check door balance before wood base is removed
Locate the 2 Phillips head countertop mounting
screws wrapped with yellow tape and stuck to the
top or side of the dishwasher. Set aside for use in
Step 10.
Check door balance by opening and closing door.
If necessary latch door and adjust one or both
springs before the wood base is removed.
Step 1. Remove leveling legs and wood base
Step 2. Install Leveling legs
Move the dishwasher close to the cabinet and lay it
on its back. Remove the four leveling
legs with an adjustable wrench.
Remove and
discard the
wood base.
Do not
“Kick”
wood base
off, damage
will occur.
Step 3. Remove toekick
Remove the two screws.
Step 4. Install 90° elbow
Install the 90° elbow fitting to the water valve using
thread seal tape on the threads. The water valve
requires 3/8” NPT fitting with external threads. The
opposite end should fit water supply line. Position the
end of the elbow to face the rear of the dishwasher.
14
Screw leveling legs back into the dishwasher frame.
The legs should extend approximately 1/4” away
from the frame.
Step 5. Position water line and power supply
Position the water supply line and house wiring on the
floor of the opening to avoid interference with base of
dishwasher and components under dishwasher.
Power
Supply
Water
Line
Note: Increase or decrease
tension as shown. Adjust
both springs to the same
tension setting to correct
balance
Insert
Hook
Over
Basket
Increase
Spring
Tension
Decrease
Spring
Tension
Correct
Incorrect
Toekick
Remove 2
Toekick Screws
90°
Elbow
Fill
Hose
Water Valve
Bracket
Thread Seal Tape
