6
HOW TO OPERATE YOUR DISHWASHER
B
5
Start
Close the dishwasher door and select the
cycle and desired enhancements. Touch the
START/RESET
pad to begin the cycle. Water fill
begins, and approximately 60 seconds later the
wash action begins.
NOTE:
The dishwasher remembers your last cycle
so you don’t have to reprogram each time. When
the dishwasher door is fully closed, the control
panel lights will display the last settings you
selected.
If you don’t want to change any of the settings,
simply touch the
START/RESET
pad to begin the
cycle.
If the door is closed the indicator lights will turn
off if the
START/RESET
pad is not selected within
two minutes. To activate the display, open and
close the door or press any pad.
Also, if a power failure occurs,
NORMAL
and
HEATED DRY
will automatically be programmed.
Make any new selections and touch the
START/
RESET
pad to begin the cycle.
Clean
The
CLEAN
light is illuminated when a
wash cycle is complete. The light will stay
ON
until the door is opened.
B
Flashing display lights.
Status Indicator Lights
What it Means
START/RESET
Cycle has been interrupted by pressing the START/RESET pad. Light will quit
flashing after the dishwasher automatically drains out the water.
Using the dishwasher.
Check the Water Temperature
The entering water should be at least
120°F and not more than 150°F, for
effective cleaning and to prevent dish
damage. Check the water temperature with a candy
or meat thermometer. Turn on the hot water faucet
nearest the dishwasher, place the thermometer in a
glass and let the water run continuously into the
glass until the temperature stops rising.
Use Jet-Dry
®
Rinse Agent
Jet-Dry
®
rinse agent removes spots and prevents new film build-up on your dishes, glasses,
flatware, cookware and plastic.
Filling the Dispenser
The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last
approximately one month. Try to keep it full, but do not overfill.
1.
Make sure the dishwasher door is fully open.
2.
Turn the dispenser knob to the left and lift it out.
3.
Add rinse agent until the indicator window looks full.
4.
Clean up any spilled rinse agent with a damp cloth.
5.
Replace the dispenser knob.
Rinse Aid Setting
The amount of risne agent released into the final wash can be
adjusted. The factory setting is at the midpoint. If there are rings
of calcium (hard water) spots on dishes, try a higher setting.
To adjust the setting
Remove the dispenser knob, then turn the adjuster counterclockwise
to increase the amount of rinse agent.
Indicator Window
Dispenser Cap
Rinse Agent
Adjuster
6
