GE Interlogix 60-875 Simon, Руководство пользователя

Страница: 19 / 40

Simon Security System 11
How to Use an
Off-Site Phone
You may use an off-site phone to arm/disarm your panel, turn lights on and off, check
system status, or conduct an audio session (ask your installer if you have this feature).
¾
How to gain access to the Control Panel:
Note
You may have to perform
steps 1 & 2 more than once.
Ask your installer how your
system is programmed.
1. Call the panel phone number and let the phone ring once then hang up.
2. Wait 10 - 40 seconds and call the panel again.
3. The panel should answer on the first ring. The panel will announce “System On” .
4. Press the * button on your telephone and you will hear “System Activated” .
At this point you may perform the actions listed in the following table of phone com-
mands. CODE refers to the master and access codes programmed into your system.
If you are interactive with your panel and the panel hangs up on you, the system is
calling in a report to the central monitoring station, pager or remote phone due to an
action made by you or someone at the security system site.
Using
Touchpads and
Keypads
Touchpads and keypads are used to control the security system from any location
within or near your home.
Touchpads and Keypads
Interfacing with the system using a Remote Handheld Touchpad and Dialog QS1500
Touchtalk Interactive Keypad is similar to using the panel.
System Status
Press System Status once to hear information about your system from the panel. See
“Status Beeps”.
ARM Doors & Windows
Press Arm Doors & Windows button once to turn the security system protection on
for all protected doors and windows.
Phone Commands
Panel Function Phone Command
DISARM ‚ + CODE + 1
ARM Doors/Windows ‚ + CODE + 2
ARM Doors/Windows with No Entry Delay ‚ + CODE + 2 + 2
ARM Motions
‚
+ CODE +
3
ARM Motions with Latchkey ‚ + CODE + 3 + 3
ARM Doors/Windows and Motions ‚ + CODE + 2 + 3
ARM Doors/Windows with No Entry Delay
and Motions with Latchkey ‚ + CODE + 2 + 2 + 3 + 3
Lights On/Off ‚ + CODE + 0
System Status ‚ + CODE + # + 1
AVM
Note
Phone commands cannot be used when the
panel is in AVM mode.
‚ + CODE + 5 + X ( X = a command
from the Audio Verification Set, 1=Talk,
2=VOX, 3=Listen)
Hang Up ‚ + CODE + 9 (Phone Command Mode)
‚ + 99 (AVM Mode)