GE IM4, Руководство пользователя и инструкции по установке

Страница: 40 / 209

40
Installation Instructions
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS M
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
or
R Q P N M L K J H G F C
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4
″
and 5/16
″
Nutdrivers
ATTACH THE WATER VALVE
•
Locate the female connector plug. Plug the
female connector
(C) onto the
male terminals
on the water valve
(4). Either wire can go on
either terminal.
2
13
•
Fasten the water valve to the cabinet by driving the
hex-head screw
(13) from the kit into the hole in
the cabinet leg.
C
4
REMOVE THE COVER
Use a 5/16
″
nutdriver or an adjustable wrench to
remove the compressor compartment access cover.
This requires removing six screws which attach the
cover to the back of the refrigerator case.
Be sure to save the screws as the access cover must
be reinstalled later to ensure your refrigerator will
function properly.
1
3
CONNECT THE WATER LINE
•
Make sure there is enough plastic water line to
extend from the water valve to well into the
water
tube inlet
(15). Cut off any excess tubing.
•
Squeeze the ends of the
hose clamp
(6) from the
kit with pliers and slide the clamp over the water
tube inlet.
•
While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1
″
[25 mm]).
•
Then slide the clamp downward to capture the
plastic water line in place.
•
Make sure the fill tube is aimed down.
6
Water tube
inlet