GE IM4, Руководство пользователя и инструкции по установке

Страница: 53 / 209

Installation Instructions
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch
to
ON
.
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
5
53
ROUTE AND ATTACH THE
PLASTIC WATER LINE
•
Fasten the
plastic water line
to the back of the
cabinet with
adhesive-backed fasteners
(5),
spacing the fasteners as shown to take up slack
in the line.
4
Adhesive-backed fasteners
for plastic water line
3
CONNECT THE WATER LINE
•
It may be necessary to remove the screw from the
top right condensor mounting clip for better
access to the water tube inlet.
•
Make sure there is enough plastic water line to
extend from the water valve to well into the
water
tube inlet
(15). Cut off any excess tubing.
•
Squeeze the ends of the
hose clamp
(3) from the
kit with pliers and slide the clamp over the water
tube inlet.
•
While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1
″
[25 mm]).
•
Then slide the clamp downward to capture the
plastic water line in place.
•
Make sure the fill tube is aimed down.
•
If the condensor mounting screw was removed,
secure the condensor to the refrigerator by
replacing the mounting clip and screw.
•
Do not overtighten the screw.
3
Water tube
inlet