GE IM4, Руководство пользователя и инструкции по установке

Страница: 17 / 209

Installation Instructions
INSTALL WATER LINE CLAMP
•
Attach the
metal water line clamp (strain relief)
(8)
to the refrigerator. Drive one of the screws,
removed in Step 1, into the cabinet edge through
the clamp and hole in compressor cover.
•
The metal clamp is for the house water line (see
Water Line Installation Instructions). It is not to
be used for the tubing from the water valve up to
the icemaker.
3
4 CONNECT THE WATER LINE
•
Remove the
small plastic cap
(B) from the bottom
of the
water tube inlet
located in the upper-right
rear corner of the refrigerator.
•
Squeeze the ends of the
hose clamp
(6) from the
kit with pliers and slide the clamp over the water
tube inlet.
•
While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1
″
[25 mm]).
•
Then slide the clamp downward to capture the
plastic water line in place.
•
Make sure the fill tube is aimed down.
ATTACH THE PLASTIC WATER LINE
Fasten the
plastic water line
to the back of the
cabinet with
adhesive-backed fasteners
(5),
spacing the fasteners as shown to take up the
slack in the line.
5
Adhesive-backed fasteners
for plastic water line
5
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the
icemaker
power switch
to
ON
.
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
6
8
Screw
17
6
Water tube
inlet
B