GE GVS04, Руководство пользователя и инструкция по установке

Страница: 4 / 32

Installing the wine center/beverage and wine center.
4
Removing the Packaging
Built-In Installation
Before using the Wine Center/Beverage and Wine Center, be sure all packing materials and
tape have been removed, including the protective film covering the control and any film
protecting the cabinet.
If you are discarding an old refrigeration product, remove the doors to reduce the danger
of children being trapped inside.
The cutout dimension shown, allows for door swing and access to the
pull-out shelves when installed as a built-in appliance. If installing between
frameless cabinets, a ½” wide filler strip or side panel may be needed on
hinge side. The filler strip will act as a spacer between the appliance case
and adjacent cabinet door swing. The width of the opening must include the
filler strip.
Note: The door should protrude 1” beyond the surrounding cabints.
To raise the appliance
„
The Wine Center/Beverage and Wine Centerr
can be freestanding or can be installed
under the counter, with proper clearances.
„
Allow the following clearances for ease
of installation, proper air circulation and
electrical connections:
Each side
0”
Top 0”
Back 0”
„
Before connecting the appliance to the
power source, let it stand upright for
approximately 2 hours. This will reduce
the possibility of a malfunction in the
cooling system from handling during
transportation.
„
Do not install the Wine Center/Beverage
and Wine Center where the temperature
will go below 55°F (12,7°C) or above 90°F
(32,2°C). If the room temperature is below
the temperature setting, the Wine Center/
Beverage and Wine Center will not operate
(for instance, if the room is at 55°F (12,7°C)
and the setting is 60°F (15,6°C), the unit
will not run).
„
Install it on a level floor.
„
Do not install the Wine Center/Beverage
and Wine Center where it will be subject to
direct sunlight, heat or moisture.
„
Do not store or install this appliance
outdoors.
Installation Guidelines
Adjustable legs at the front corners of the
Wine Center/Beverage and Wine Center should
be set so the Wine Center/Beverage and Wine
Center is firmly positioned on the floor, with a
1/8
”
tilt to the back to help the door closure.
To adjust the leveling legs, turn the legs
counterclockwise to raise the beverage
center/wine chiller, clockwise to lower it.
Leveling Legs
19"
482.6 mm
19-1/2" Min.
495.3 mm Min.
22-1/2"
569 mm
including door
19"
495.3 mm
6" Max.
152 mm Max.
33-1/2" Min.
851 mm Min.
23-1/2" Min
597mm Min.
33"
838 mm
Locate Outlet