GE GUD24ESSMWW, Техническое обслуживание руководство

Страница: 42 / 81

– 42 –
Top Cover Assembly Removal
1. Remove the front panel. (See Front Panel in
this section of this service guide.)
2. Remove the two 1/4-in. hex-head screws that
attach the top cover assembly to the washer
3. Open the lid and remove two Phillips-head
screws that secure the lid lock to the top
cover. Pull the lid lock assembly from under
the top cover, disconnect the lid lock harness
from the lid lock assembly and set it aside.
4. Reach under the top cover assembly, and
WKHQ¿UPO\SUHVVLQRQWKHIURQWORFNWDEWR
release the lid switch. Push it up from the
opening in the top cover assembly.
5. Pull the cover assembly from the washer.
Tab
Lid Switch
Disconnect
Tub Outlet
Hose
Pump
Outlet
Hose
The drain pump receives 120 VAC from control
board location J512 pin 2 to pin 3.
The drain pump motor has an approximate
resistance value of 10.9 ohms 27-inch models
and 16.4 ohms on 24-inch models.
NOTE:
‡ The pump runs whenever the washer is in the
spin function of a cycle.
‡ 7KHGUDLQSXPSZLOORSHUDWHLIDQRYHU¿OO
FRQGLWLRQKDVRFFXUUHG2YHUÀRZSURWHFWLRQ
and 120 VAC is present at control board
location J101 pin 1 to pin 2. The pump will
lower the water level to the setting selected
on the LOAD SIZE control.
The drain pump is located in the bottom left front
of the unit. The outlet hose from the bottom of
the tub uses a 5/16-in. hex-head hose clamp at
the tub and spring clamps at the input and output
of the pump.
Drain Pump Removal
1. Remove the front panel (see Front Panel in
this section of this service guide).
2. Disconnect the pump wires.
NOTE: Water will remain in hoses even when the
tub appears empty. Use care to avoid water spills.
3. Remove the spring clamps and hoses from
the pump.
4. Remove two 1/4-in. hex-head screws that
attach the drain pump to the washer chassis.
Top Cover Assembly Drain Pump